ETC PENKO SGM800 Manual page 36

MANUAL SGM800
2.1.2 Menu -ACn-
ACn setpoint action settings (not for SGM810 or controller)
To set the hysteresis for the outputs press key 2 <2 sec to enter the setpoint
function settings menu.
Select the output you want to configure pressing key 1 <2 sec. Acn 1= output 1, Acn 2=
output 2, Acn 3= output 3 and Acn 4= output 4. Confirm the selected out- put by
pressing key 2 <2 sec.
The following screen is visible:
Fill in the hysteresis for the outputs. Use key 1 and 2 to change the value. Key 1 is for
changing the number (1-9), key 2 is for changing the position of the cursor. Confirm by
pressing key 3 for >2 sec.See diagram next page.
Choose value between -99999 and 999999.
36