ETC PENKO SGM800 Manual page 83

MANUAL SGM800
The following screen is visible:
In tcL 3 you can set the loadcell sensitivity for loadcell 2. This information can be found on
the datasheet delivered with the loadcell. Press key 2 <2 sec. to set the loadcell
sensitivity.
The following screen is visible:
Use key 1 and key 2 to enter the sensitivity of loadcell 2. Key 1 is used for
changing the number (1-9), key 2 is used for changing the position of the
cursor. Sensitivity has to be filled in as 0.00000 mV/V. Press key 3 >2 sec. to set the
sensitivity of the loadcell.
Up
The following screen is visible:
In tcL 4 you can set the loadcell sensitivity for loadcell 3. This information can be found on
the datasheet delivered with the loadcell. Press key 2 <2 sec. to set the loadcell
sensitivity.
The following screen is visible:
Down Left Right Confirm
83