Weigher Settings - ETC PENKO SGM800 Manual

MANUAL SGM800
1.6

Weigher settings-

Set up the correct indicator setting (step size and decimal point position).
Turn the indicator on by connecting it to the power supply.
Press key 3 for >2 sec. to get in to Configuration Menu.
Go to the Indicator parameters pressing key 1 <2 sec.
Go into the Indicator parameters pressing key 2.
Use Ind 1 to set the maximum net weight value. Set maximum load to prevent
overload by the user. The indicator will not show any weight above the filled in
value. Range: 0 – full display.
To change the value, press key 2 <2 sec.
Use key 1 and 2 to change the value. Key 1 is for changing the number (1-9), key
2 is for changing the position of the cursor. Confirm by pressing key 3 for >2 sec.
Up
When the maximum net weight value is set successfully, the following screen is
visible:
Down Left Right Confirm
(In SGM810 or controller)
17