Troubleshooting - Touch Pad; Error Codes - Lippert Components Level Up Installation And Owner's Manual

Troubleshooting - Touch Pad

Error Codes

NOTE: To clear an error from the touch pad, repair or
otherwise correct the issue, then press "ENTER". If the
error is still present, the message will be displayed again.
LCD Message What's Happening?
Controller not properly secured.
****ERROR****
Excess Angle Excessive angle reached during auto operation.
Controller not properly secured.
****ERROR****
Excessive angle reached during manual operation.
Excessive Angle
Front of trailer below level when starting Auto Level process
(only when trying to initiate Hitch Recognition).
****ERROR****
Touch pad power not cycled between consecutive leveling
Feature Disabled
operations.
Zero point not set.
****ERROR****
Battery voltage dropped below 9.5V.
Low Voltage
****ERROR****
Jack has reached maximum stroke length and is unable to
lift.
Out Of Stroke
****ERROR****
Bad connection or wiring from the controller to the rear
sensor.
External Sensor
****ERROR****
Time limit exceeded for the requested auto operation.
Jack Time Out
Unable to auto level due to uneven ground.
****ERROR****
Unable to auto level due to zero point being set incorrectly.
Auto Level Fail
****ERROR****
Sensor calibration values are out of range.
Bad Calibration
****ERROR****
Internal sensor problem.
Internal Sensor
**PANIC STOP** The user pressed a button on the touch pad during an
Function Aborted automatic operation.
lci1.com 574-537-8900
Level Up
Installation and Owner's Manual
(For Aftermarket Application)
ENSURE THE TRAILER IS SUPPORTED AT BOTH THE
FRONT AND REAR WITH JACK STANDS BEFORE
PERFORMING ANY TROUBLESHOOTING OR SERVICE
TO THE TRAILER. FAILURE TO DO SO MAY RESULT IN
DEATH OR PERSONAL INJURY.
What Should Be Done?
Check and secure controller placement.
Relocate the trailer.
Check and secure controller placement.
Relocate the trailer.
Push the "FRONT" button to raise the trailer up to hitch height and
connect to tow vehicle.
Turn touch pad off and then back on to reset the system.
Set zero point.
Check wiring - repair or replace.
Test battery voltage under load - charge or replace.
Check disposition of jacks and/or relocate the trailer.
Replace or repair connection to rear remote sensor.
Check disposition of jacks.
Check disposition of jacks and/or relocate the trailer.
Reset zero point.
Replace controller.
Replace controller.
Restart automatic operation and then refrain from pressing any buttons
on the touch pad.
15
CCD-0001533
™
Rev: 06.29.18