Troubleshooting; Auto Leveling Control Touch Pad; Error Display In Onecontrol Touch Panel Or Onecontrol App - Lippert Components Ground Control TT Installation And Owner's Manual

Troubleshooting

Red/Green LED Indicator on Auto Leveling Control Touch Pad
What is Happening?
Off
Solid Green
Blinking Green
Solid Red
Blinking Red

Error Display in OneControl Touch Panel or OneControl App

NOTE: Errors can only be cleared via the OneControl Touch Panel or OneControl Leveling App. The only exception is when the
Auto Leveling Control Touch Pad (Fig.28) was used to abort an auto-sequence. In this case the error can be cleared by pressing
any Auto Leveling Control button. To clear an error, correct the issue, then press "OK." If the error is still present, the message
will be displayed again.
Touch Panel Message
"EXCESS ANGLE"
"EXCESSIVE ANGLE"
"BAD CALIBRATION"
"FEATURE DISABLED"
"LOW VOLTAGE"
"OUT OF STROKE"
"EXTERNAL SENSOR"
"JACK TIME OUT"
"AUTO LEVEL FAILURE"
"FUNCTION ABORTED"
"HALL POWER SHORT"
"CAN'T COMPLETE LEVEL
IN THIS LOCATION.
PLEASE RELOCATE RV
TO FLATTER TERRAIN"
lippertcomponents.com
Why?
Touch panel is locked.
Touch panel is active.
Jacks are moving.
Low battery.
Error - Refer to OneControl Touch Panel screen or the Leveling App for the specific error, then
consult the Troubleshooting section of this manual to clear the error.
What's Happening
Unsecured controller.
Uneven or sloped site.
Excessive angle reached during manual
operation.
Trailer zero point was not set correctly.
Hitch recognition requested but no hitch
height set.
Zero point not set.
Bad connection or wiring.
Discharged or bad battery.
Unsecured controller.
Uneven or sloped site.
Bad connection or wiring.
System could not level in expected time.
Unsecured controller.
Voltage drop.
User has aborted an automatic leveling sequence.
Short circuit detected on one or more of the jack
hall effect power lines.
The trailer is parked on a steep incline during auto
level. The front cannot be leveled and the front
jacks are already fully retracted.
574-537-8900
Ground Control
Leveling OneControl
Touch Panel
Installation and Owner's Manual
(For Aftermarket Applications)
What Should I Do?
Check and secure controller placement.
Relocate the trailer.
Stop manual operation and reset jacks to a more level
state. The code will self-clear. There is no need to hit
"OK."
Reset zero point.
Perform "AUTO LEVEL" sequence to
establish hitch height.
Set zero point.
Check wiring - repair or replace.
Test battery voltage under load - charge or replace.
Check and secure controller placement.
Relocate the trailer.
Replace or repair connection to rear remote sensor.
Check disposition of jacks.
Check and secure controller placement.
Test battery voltage under load - charge or replace.
Restart the sequence.
Check harness and replace or repair.
Relocate the trailer.
26
Rev: 08.17 - GC
TT
®
TT Leveling OneControl
®
®
Touch Panel
®