Troubleshooting; Red/Green Led Indicator On Auto Leveling Control Touch Panel; Onecontrol Touch Panel Error Codes - Lippert Components Ground Control 3.0 Owner's Manual

Troubleshooting

Red/Green LED Indicator on Auto Leveling Control Touch Panel

What Is Happening?
Off
Solid Green
Blinking Green
Solid Red
Blinking Red

OneControl Touch Panel Error Codes

NOTE: Faults can only be cleared via the OneControl Touch Panel or OneControl Leveling App through
MyRV®. The only exception is when the Auto Leveling Control Touch Panel (Fig. 1) was used to abort
an auto-sequence. In this case the fault can be cleared by pressing any Auto Leveling Control button.
Touch Panel
Message
"EXCESS ANGLE"
"EXCESSIVE ANGLE"
"BAD CALIBRATION"
"FEATURE DISABLED"
"LOW VOLTAGE"
"OUT OF STROKE"
"EXTERNAL SENSOR"
"JACK TIME OUT"
"AUTO LEVEL FAIL"
"FUNCTION ABORTED"
"HALL POWER SHORT"
Rev: 03.02.2017
Why?
Touch panel is locked.
Touch panel is active.
Jacks are moving.
Low battery.
Error - Refer to OneControl Touch Panel screen or the Leveling App for the
specific error, then consult the Troubleshooting section of this manual to clear
the error.
What's Happening?
Unsecured controller.
Uneven or sloped site.
Controller not properly secured.
Excessive angle reached during
manual operation.
Trailer zero point was not set
correctly.
Hitch recognition requested but no
hitch height set.
Zero point not set.
Bad connection or wiring.
Discharged or bad battery.
Unsecured controller.
Uneven or sloped site.
Bad connection or wiring.
System could not level in expected
time.
Unsecured controller.
Voltage drop.
User has aborted an automatic
leveling sequence.
Short circuit detected on one or
more of the jack hall effect power
lines.
What Should I Do?
Check and secure controller placement.
Relocate the trailer.
Check and secure controller placement.
Relocate the coach.
Reset zero point.
Perform "AUTO LEVEL" sequence to
establish hitch height.
Set zero point.
Check wiring - repair or replace.
Test battery voltage under load - charge or
replace.
Check and secure controller placement.
Relocate the trailer.
Replace or repair connection to rear remote
sensor.
Check disposition of jacks.
Check and secure controller placement.
Test battery voltage under load - charge or
replace.
Hit OK. Restart the sequence.
Check harness and replace or repair.
Page 13
Ground Control 3.0 with OneControl