Setting The Relative Or Absolute Tolerance - WAGO 753-668/000-004 Manual

58 Functions
4.7

Setting the Relative or Absolute Tolerance

Depending on which setting is used for the tolerance window (relative, absolute
or relative + absolute), the relative or absolute parameter values must be set.
The settings are made via the "Relative Tolerance" parameter and/or "Absolute
Tolerance", which is described in Section "Commissioning" > ... > "Setting
Parameters".
The following parameters must also be set:
•
Tolerance window
•
Sensor evaluation
•
Discrepancy time
Manual
Version 1.0.0, valid from HW/SW Version 01/01
753-668/000-004 4FAI 0/4-20 mA Diff PROFIsafe
WAGO-I/O-SYSTEM 750