Profisafe Address Set Using The Parameterization Tool - WAGO 753-668/000-004 Manual

134 Service
10.1.3.2

PROFIsafe Address Set Using the Parameterization Tool

If the coding switch of the F I/O module to be replaced is set to 0, the PROFIsafe
address of the replacement module must be set through the WAGO
parameterization tool (see Section "Commissioning" > ... > "Parameterization of
the F I/O Module with the WAGO Parameterization Tool"). After setting the
PROFIsafe address, set the parameters for the replacement I/O module using
the WAGO parameterization tool (see section "Commissioning" > ... >
"Parameterization of the F I/O Module with the WAGO Parameterization Tool").
Determining the PROFIsafe address when the coding switch is set to "0"!
The PROFIsafe address of the F I/O module to be replaced must be entered in
the system documentation.
Manual
Version 1.0.0, valid from HW/SW Version 01/01
753-668/000-004 4FAI 0/4-20 mA Diff PROFIsafe
WAGO-I/O-SYSTEM 750