Table 20: Setting Options For I/O Module 750-469/040-000 - WAGO 750-469/040-000 Manual

34 Process Image

Table 20: Setting Options for I/O Module 750-469/040-000

Selection box
Sensor Type
Check Lower Range
State bits
Watchdog Timer
Amount Sign
Filter Constants
Cold Junction
Compensation
Wire Break Detection
User Scaling
WAGO Scaling
*)
Default setting
To adjust the offset and gain values of the user and manufacturer scaling, the
following input fields are available in WAGO-I/O-CHECK:
Manual
Version 1.3.0
750-469/040-000 2AI Thermocouple configurable /XTR
Possible settings
L: −100 °C ... +900 °C
K: −100 °C ... +1370 °C
J: −100 °C ... +1200 °C
E: −100 °C ... +1000 °C
T: −100 °C ... +400 °C
S: −50 °C ... +1700 °C
N: −100 °C ... +1300 °C
U: −25 °C ... +600 °C
B: +600 °C ... +1800 °C
R: 0 °C ... +1700 °C
±30 mV / ±60 mV / ±120 mV
OFF Status bit 0 is not used when falling below the
measuring range.
*)
ON Status bit 0 is used when falling below the
measuring range.
*)
OFF No display of status indicators
ON Display of status indicators in the bottom 3 bits:
Bit 0: Overflow. Used when the measured value
lies outside the permitted range.
Bit 1: Error. Used when the I/O module detects
an error in the internal function or a wire break.
Bit 2: 0
OFF Watchdog timer not enabled.
*)
ON Watchdog timer enabled. If not process data is
exchanged with the fieldbus coupler/controller,
the green LEDs go out.
*
OFF Two's complement representation
ON Amount/sign representation
12.5 Hz – 640 ms / 50 Hz – 320 ms
100 Hz – 160 ms / 200 Hz – 80 ms
OFF Do not compensate for cold junction
temperature
*)
ON Compensate for cold junction temperature
OFF Wire break monitoring disabled
*)
ON Wire break monitoring enabled
*)
OFF User scaling disabled
ON User scaling enabled
OFF WAGO scaling disabled
*)
ON WAGO scaling enabled
WAGO-I/O-SYSTEM 750 XTR
*)
*)
/