Upgrading projectors to version 1.1.0 or newer software Christie is continuously improving the GS Series product line. To make sure you are getting the best experience, version 1.1.0 or newer software is mandatory for the ultra short throw lens application.
Page 9
Ultra short throw lens installation 9. If not mounting the projector using Christie One Mount, complete the following steps: a) Attach the lens support bracket assembly to the bottom surface of the projector. b) Install the two M6x22 hex screws and two M6 washers in the mounting holes of the projector.
Page 10
Position two pillars of Christie One Mount to the lens support bracket and the other two pillars on the projector as shown below. c) To fasten the two rear pillars of Christie One Mount to the projector, install the two M3x8 hex screws (no washers required) provided with Christie One Mount.
Page 11
The boresight extensions rods must be installed before installing the ultra short throw lens. Initially adjusting the boresight screws Before installing the ultra short throw lens, Christie recommends initially adjusting the boresight. Once the lens is installed, the adjustment range is limited.
Page 15
Ultra short throw lens installation 9. For 630-GS and 635-GS only, Christie recommends installing the rubber boot. Christie recommends keeping the boresight extenders in place in case you need to adjust boresight again. Removing the ultra short throw lens A long neck screwdriver is required to release the lens.