Christie GS Series Service Manual page 86

Item Male connector on
connector board
W J62 MB TO LD BD 2
X J9 LIGHT SENSOR 1
Y J1 MB TO LVPS CNNT
Z J31 FAN3/J30 FAN2/J29
FAN1
4. Remove the harnesses from the clips.
5. On the main board, remove the nine M3 screws with a Phillips #1 screwdriver.
6. On the I/O cover, remove the four M3 screws with a Phillips #1 screwdriver.
7. On the I/O cover, remove the eight hex screws with an M3 socket driver.
GS Series 1075 Service Manual
020-001236-02 Rev. 1 (12-2019)
Description
Composed of a white connector, and a black wire tube
(12 pin)
Composed of black, yellow, and red wires, a white
connector, and a black wire tube (six pin)
Composed of a white connector, and a black wire tube
(22 pin)
Composed of black, blue, gray, and brown wires, a
white connector, and a black wire tube (four pin)
Printed circuit boards and sensors
Figure
86