Removing The Left-Side Cover - Christie GS Series Service Manual

3. Remove the front cover.
See Removing the front cover
4. Remove the rear cover.
See Removing the rear cover
5. At both ends of the cover, remove the four M3 screws with a Phillips #1 screwdriver securing
the right-side cover module.
6. Loosen the four captive M3 screws with a Phillips #1 screwdriver.
7. Remove the right-side cover from the projector.
8. To separate the right-side cover from fans 1, 2, and 3, remove the 12 M3 screws with a Phillips
#1 screwdriver.
9. Transfer the fans to the new right-side cover.
10. If required, replace the right-side cover.
11. To re-install, follow these steps in reverse order.

Removing the left-side cover

The left-side of the projector is determined by facing forward from rear of the projector.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board and I/O board.
See Replacing the main board and I/O board
3. Remove the front cover.
See Removing the front cover
GS Series 1075 Service Manual
020-001236-02 Rev. 1 (12-2019)
on page 65.
on page 64.
on page 63.
on page 83.
on page 65.
Projector covers and feet
66