Preset Plug - Siemens SIMATIC NET SCALANCE S615 Configuration Manual

Command Line Interface (CLI) and PROFINET diagnostics). The user then has the choice of
either removing the PLUG again or selecting the option to reformat the PLUG.
Type
C-PLUG
KEY-PLUG SINEMA RC Exchangeable storage medium (256 MB) to enable
1.7.2

PRESET PLUG

PLUG with preset function (PRESET-PLUG)
With PRESET-PLUG it is possible to install the same configuration and the firmware belonging
to it on several devices.
Note
Using configurations with DHCP
Create a PRESET-PLUG only from device configurations that use DHCP. Otherwise
disruptions will occur in network operation due to multiple identical IP addresses.
You assign fixed IP addresses extra following the basic installation.
In a PLUG that was configured as a PRESET-PLUG, the device configuration, user accounts,
certificates and the firmware are stored.
Note
Restore factory defaults and restart with a PRESET PLUG inserted
If you reset a device to the factory defaults, when the device restarts an inserted PRESET
PLUG is formatted and the PRESET PLUG functionality is lost. You then need to create a new
PRESET PLUG.
We recommend that you remove the PRESET PLUG before you reset the device to the factory
settings.
For more detailed information on creating and using a PRESET PLUG refer to the section
Device configuration with PRESET-PLUG (Page 297).
SCALANCE S615 Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C388-08
Properties
Exchangeable storage medium (32 MB) for the con‐
figuration data
Exchangeable storage medium (256 MB) for the con‐
figuration data
the connection functionality to SINEMA Remote Con‐
nect and for accepting configuration data.
Description
1.7 PLUG
Article number
6GK1900-0AB00
6GK1900-0AB10
6GK5908-0PB00
23