Configuring with Web Based Management
4.4 "System" menu
4.4.12
PLUG
4.4.12.1
Configuration
NOTICE
Do not remove or insert a C-PLUG / KEY-PLUG during operation!
A PLUG may only be removed or inserted when the device is turned off.
The device checks whether or not a PLUG is present at one second intervals. If it is
detected that the PLUG was removed, there is a restart. If a valid KEY-PLUG was inserted
in the device, the device changes to a defined error state following the restart.
If the device was configured at some time with a PLUG, the device can no longer be used
without this PLUG. To be able to use the device again, reset the device to the factory
settings.
Information about the configuration of the KEY-PLUG
This page provides detailed information about the configuration stored on the C-PLUG. It is
also possible to reset the PLUG to "factory defaults" or to load it with new contents.
Note
The action is only executed after you click the "Set Values" button.
The action cannot be undone.
If you decide against executing the function after making your selection, click the "Refresh"
button. As a result the data of this page is read from the device again and the selection is
canceled.
102
SCALANCE S615 Web Based Management
Configuration Manual, 05/2015, C79000-G8976-C388-02