Siemens SIMATIC NET SCALANCE S615 Configuration Manual page 218

Configuring with Web Based Management
4.7 "Layer 2" menu
● Status
Shows the status type of the entry in the internal port filter table. Here, "Static" means that
the VLAN was entered statically by the user.
● List of ports
Specify the use of the port. The following options are available:
– "-"
– M
– U (uppercase)
– u (lowercase)
– F
– T
Changing Base bridge mode
VLAN-unaware (802.1D transparent bridge) → VLAN-aware (802.1Q VLAN bridge)
If you change the Base bridge mode from VLAN-unaware to VLAN aware, this has the following
effects
● All static and dynamic unicast entries are deleted.
VLAN-aware (802.1Q VLAN bridge) → VLAN-unaware (802.1D transparent bridge)
If you change the Base bridge mode from VLAN-aware to VLAN-unaware, this has the following
effects
● All VLAN configurations are deleted.
● A management VLAN is created: VLAN 1.
● All static and dynamic unicast entries are deleted.
218
The port is not a member of the specified VLAN.
With a new definition, all ports have the identifier "-".
The port is a member of the VLAN. Frames sent in this VLAN are forwarded with the
corresponding VLAN tag.
The port is an untagged member of the VLAN. Frames sent in this VLAN are forwarded
without the VLAN tag. Frames without a VLAN tag are sent from this port.
The port is an untagged member of the VLAN, but the VLAN is not configured as a port
VLAN. Frames sent in this VLAN are forwarded without the VLAN tag.
The port is not a member of the specified VLAN and cannot become a member of this
VLAN even if it is configured as a trunk port.
This option is only displayed and cannot be selected in the WBM.
This port is a trunk port making it a member in all VLANs.
You configure this function in the CLI (Command Line Interface) using the
"switchport mode trunk" command or in the WBM under "Interfaces > Ethernet >
Configuration".
SCALANCE S615 Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C388-08