Traps - Siemens SIMATIC NET SCALANCE S615 Configuration Manual

● SNMP Engine ID
Shows the SNMP engine ID.
● SNMP Agent Listen Port
Specify the port at which the SNMP agent waits for the SNMP queries.
Procedure
1. Select the required option from the "SNMP" drop-down list:
– "-" (disabled)
– SNMPv1/v2c/v3
– SNMPv3
2. Enable the "SNMPv1/v2c Read Only" check box if you only want read access to SNMP
variables with SNMPv1/v2c.
3. Enter the required character string in the "SNMPv1/v2c Read Community String" input box.
4. Enter the required character string in the "SNMPv1/v2c Read/Write Community String"
input box.
5. If necessary, enable the SNMPv3 User Migration.
6. Click the "Set Values" button.
4.5.7.2

Traps

SNMP traps for alarm events
If an alarm event occurs, a device can send SNMP traps (alarm frames) to up to ten different
management stations at the same time. Traps are only sent if the events specified in the
"Events" menu occur.
Note
Traps are only sent if you have enabled the option "SNMPv1 Traps" in the "General" tab or in
"System > Configuration".
SCALANCE S615 Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C388-08
Configuring with Web Based Management
4.5 "System" menu
149