Siemens SIMATIC NET SCALANCE S615 Configuration Manual page 211

Description
● Port
Select the port to be configured from the drop-down list.
● Status
Specify whether the port is enabled or disabled.
– enabled
– disabled
– link down
● Port Name
Here, enter a name for the port.
● MAC Address
Shows the MAC address of the port.
● Mode Type
From this drop-down list, select the transmission speed and the transfer mode of the port.
The following settings are possible:
– 10 Mbps full duplex (FD) or half duplex (HD)
– 100 Mbps full duplex (FD) or half duplex (HD)
– Auto negotiation
If you set the mode to "Auto negotiation", these parameters are automatically negotiated
with the connected end device or network component. This must also be in the
"Autonegotiation" mode.
Note
Before the port and partner port can communicate with each other, the settings must match
at both ends.
● Mode
Shows the transmission speed and the transmission mode of the port. The display depends
on the set "Mode Type".
● Negotiation
Shows whether the automatic configuration of the connection to the partner port is enabled
or disabled.
SCALANCE S615 Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C388-08
The port is enabled. Data traffic is possible only over an enabled port.
The port is disabled but the connection remains.
Note
Turn off unused ports.
The port is disabled and the connection to the partner device is terminated.
Configuring with Web Based Management
4.6 "Interfaces" menu
211