Siemens SIMATIC NET SCALANCE S615 Configuration Manual page 122

Configuring with Web Based Management
4.5 "System" menu
Description
To restart the device, the buttons on this page provide you with the following options:
● Restart
Click this button to restart the system. You must confirm the restart in a dialog box. During
a restart, the device is reinitialized, the internal firmware is reloaded, and the device runs a
self-test. The settings of the start configuration are retained, e.g. the IP address of the
device. The learned entries in the address table are deleted. You can leave the browser
window open while the device restarts. After the restart you will need to log in again.
● Restore Memory Defaults and Restart
Click this button to restore the factory defaults of the device with the exception of the
following parameters and to restart the device:
– IP addresses
– Subnet mask
– IP address of the default gateway
– DHCP client ID
– DHCP
– System name
– System location
– System contact
– Mode of the device
– Login text
● Restore Factory Defaults and Restart
Click this button to restore the factory defaults of the device and to restart the device. You
must confirm the restart in a dialog box.
Note
By resetting to the factory configuration settings, the device is reachable again with the IP
address 192.168.1.1 set in the factory, see the section "Requirements for operation".
You configure the scheduled restart under "Restart in:"
– x seconds
– Schedule restart
– Cancel scheduled restart
122
Specify the time after which the device restarts.
When you click this button, a timer starts and runs backwards with the defined time.
When the timer has expired, the device restarts.
With this button you disable the timer for the scheduled restart.
SCALANCE S615 Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C388-08