Openvpn Client; General - Siemens SIMATIC NET SCALANCE S615 Configuration Manual

Configuring with Web Based Management
4.9 "Security" menu
● Lifebytes
Enter the data limit in bytes that specifies the lifetime of the agreed key. When the data limit
is reached, the key is renegotiated.
● Protocol
Specify the protocol for which the VPN connection is valid e.g. UDP, TCP, ICMP. If the
setting is intended to apply to all protocols, enter "*".
● Port (Range)
Specify the port via which the VPN tunnel can communicate. The setting applies specifically
to the specified port
– If the setting is intended to apply to a port range, enter the range with start port "-" end
– If the setting is intended to apply to all ports, enter "*".
The setting is only effective for port-based protocols.
● Auto Firewall Rules
– enabled
– disabled
4.9.7

OpenVPN client

4.9.7.1

General

On this WBM page, you enable the OpenVPN client.
Description
The page contains the following:
● Activate OpenVPN Client
Enable or disable the OpenVPN client.
292
port, for example 30 - 40.
For the VPN connection, the firewall rules for access from "External" to "Internal" and
vice versa are created automatically. You can enable access to specific services of the
device under "Security > Firewall > Predefined IPv4". Ping is enabled by default.
You will need to create the firewall rules yourself.
SCALANCE S615 Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C388-08