Troubleshooting; Derror Icons Of The Transceiver - Icom IC-705 Advanced Manual

15. ABOUT THE DV GATEWAY FUNCTION

Troubleshooting

DError icons of the transceiver

If an error icon is displayed when using the Internal Gateway function, read the following chart. If you
are unable to locate the cause of a problem or solve it through the use of this chart, contact your Icom
Dealer or Service Center.
Icon Possible Cause
Transceiver connection is wrong.
Gateway Repeater cannot be
found.
The call sign has not been added
to "Allowed Call Sign List" in the
transceiver, when "Allowed Call
Sign" is set to "Enable."
Your call sign (MY) has not been
registered at a gateway server.
The Terminal/AP call sign that is
set in the transceiver has not been
registered in the RS-RP3C as the
access point.
Destination station's call sign (UR)
has not been registered to the
gateway server, or the call sign
do not match your transceiver's
setting.
Destination station that uses
the Terminal mode or Access
Point mode does not transmit
periodically.
The repeater is busy.
A signal is received while
transmitting.
The transceiver cannot receive the
signal.
15-21
Solution
Check the connection between
the transceiver and the router.
Check the WLAN settings.
Set "Allowed Call Sign" to
"Disable" in the INTERNAL
GATEWAY SETTINGS screen.
Add the Remote D-STAR
transceiver's call sign to "Allowed
Call Sign List" in the INTERNAL
GATEWAY SETTINGS screen.
Register your call sign (MY) at a
gateway server.
Register the Terminal/AP call sign
that is set in the transceiver in the
RS-RP3C as the access point.
Check the destination station's
register information.
Destination station makes a call.
Wait for a while, and try again.
Destination station makes a call
again.
Destination station makes a call
again.
REF�
p. 15-10
p. 15-6
p. 15-11
p. 15-11
p. 13-4
p. 13-4
–
–
–
–
–