Dauto Position Reply Function - Icom IC-705 Advanced Manual

14. D-STAR OPERATION (ADVANCED)
Automatic Reply function

DAuto Position Reply function

When you receive a call addressed to your own
call sign, but are in a situation that makes it
difficult to operate the transceiver, this function
sounds beeps and automatically replies with your
own call sign and transmits your position data.
After receiving the Auto Position Reply call, the
caller's position data is displayed in a window.
LIcom transceivers* displays the position after
receiving a call.
LYou can turn OFF the caller's position display.
» SET > Display > Reply Position Display
* Except for the ID-31A/E, IC-9100, ID-880H/E880,
IC-80AD/E80D, IC-92AD/E92D, IC-2820H/E2820,
ID-800H, IC-91AD/E91, IC-V82, IC-U82
When no valid position data is received
After receiving a call addressed to your own call
sign, the internal GPS receiver is temporarily
turned ON for approximately 5 minutes to receive
your position data, even if "GPS Select" is set to
"OFF" or "Manual."
» GPS > GPS Set > GPS Select
LWhen the internal GPS receiver is temporarily ON,
and valid position data is received, the transceiver
transmits your position data if a call addressed to
your own call sign is received again.
2. Your position data is
automatically transmitted.
JA3YUA
Your station
3. After receiving, position
data is displayed on the
destination's transceiver.
TIP:
• The position data is transmitted according to the
"GPS TX Mode."
• When the "GPS TX Mode" settings are incorrect
for the Automatic Reply function, the transceiver
automatically corrects them to reply to a call.
• When "GPS TX Mode" is set to "OFF," "D-PRS" is
automatically selected.
14-19
Destination
(IC-705)
1. You receive a call
addressed to your own
call sign.