Icom IC-705 Advanced Manual page 128

12. GPS OPERATION (ADVANCED)
GPS SET
» GPS > GPS Alarm
Alarm Area (RX/Memory)
Selects the GPS active alarm range.
When a target enters the active alarm range,
the GPS Alarm sounds, and the GPS alarm icon
blinks.
LWhen "Alarm Select" is set to "RX" or "Memory," this
setting is enabled. (p. 12-44)
• Limited: The transceiver sounds 3 beeps,
and the GPS Alarm icon blinks
when the target enters the 500
meters range.
• Extended: The transceiver sounds 3 beeps,
and the GPS Alarm icon blinks
when the target enters the 1
kilometer range.
• Both: The transceiver sounds a beep, and
the GPS Alarm icon blinks when the
target enters the 1 kilometer range,
and sounds 3 beeps, and the icon
blinks when it enters the 500 meters
range. When the target exits the
500 meters range, but is still in the 1
kilometer range, the icon continues
to blink, but no beeps sound.
Example:
When a target station enters the active alarm
range (500 meters or 1 kilometer range,
depending on the setting), the GPS Alarm
sounds and the GPS Alarm icon blinks.
Extended range
approximately 1 km, 1094 Y
approximately 500 m, 547 Y
Your location
Target
station
Sounds a beep.
(Default: Both)
Limited range
Sounds 3 beeps.
» GPS > GPS Logger
GPS Logger
Turns the GPS Logger function ON or OFF.
This function logs the position, altitude, course,
speed, and a number of satellites being used.
• OFF: Turns OFF the function.
• ON: The transceiver automatically logs
GPS data. Once this function is turned
ON, the GPS data will be continuously
logged until turning it OFF, even if the
transceiver power is turned OFF, then
ON again.
LThis function requires a microSD card (User
supplied).
LWhen "GPS select" is set to "OFF" or "Manual," this
function does not save the log.
TIP: The log data is saved on the microSD
card. The file name is automatically created, as
shown below:
• Log start date and time: 1st January 2020 15:30:00
• File name:
Record Interval
Sets the GPS Logger function record interval to
1, 5, 10, 30, or 60 seconds.
Record Sentence
(Default:
Sets the GPS Logger function record sentence to
RMC, GGA, VTG, or GSA.
• Displays "✓" when the sentence is set.
N
NOTE: Select at least one sentence, otherwise
an error beep will sound.
12-45
(Default: ON)
20200101_153000.csv
(Default: 10sec)
RMC/ GGA/ VTG/
✔ ✔ ✔
GSA)
✔