Dwhen Connecting Your Device To The Internet Using A Mobile Router - Icom IC-705 Advanced Manual

15. ABOUT THE DV GATEWAY FUNCTION
Setting up a network

DWhen connecting your device to the Internet using a mobile router

The following items are needed to use the DV
Gateway function.
• An Internet connection with an IPv4 Global IP
address
• A static* 1 local IP address set to your transceiver,
Windows, or Android device
• Port forwarding of port 40000
* 1 A static IP address to the transceiver, Windows, or
Android device is recommended.
* Needs a Global IP address and forwarding port
2
number 40000.
1� A Global IP address
A static or dynamic IPv4 Global IP address assigned to the router is needed.
LYour router may not have a Global IP address, depending on your Internet service provider.
Ask your Internet service provider about the Global IP address setting.
2� Setting a static local IP address
When using a mobile router, you need to set a static local IP address to the transceiver, Windows, or Android
device.
LUsable IP addresses differ, depending on your router. Ask the router's manufacturer for details.
LDo not set the same IP address to two or more devices that are connected to the same router.
LAsk your Windows or Android device's manufacturer about the setting details.
LSee page 15-6 for the transceiver's setting details.
3� Port forwarding
When using a mobile router, enable communication with the Internet, as described below.
• Forward the port number 40000 to the transceiver, Windows, or Android device.
• "UDP" should be used as the port protocol.
• Set a static local IP address in Procedure 2 (2. Setting a static local IP address) as a destination port.
LAsk the router's manufacturer about how to forward the port.
LOnly one transceiver, Windows, or Android device connected to the router can use the DV Gateway function at
the same time.
LDepending on the router settings, you must configure the IP filter settings. Check the router's manual on how to
configure the settings.
 When using the Internal Gateway function, go to "Setting up the transceiver." (p. 15-10)
 When using a Windows device, go to "Setting up the RS-MS3W." (p. 15-12)
 When using an Android device, go to "Setting up the RS-MS3A." (p. 15-13)
* 1
USB
cable
USB cable
15-9
INTERNET INTERNET
*
2
* 2
* 1
* 2
* 1