When Receiving No Reply - Icom IC-705 Advanced Manual

13. D-STAR OPERATION (BASIC)

When receiving no reply

To communicate through a repeater, your signal must access the repeater. The following chart is
designed to help you correct problems which are not equipment malfunctions.
Problem
After your call, the repeater does
not return a status reply.
After your call, 'UR?' and its call
sign are displayed.
After your call, 'RX' or 'RPT?'
and the access repeater's call
sign are displayed.
After your call, 'RPT?' and the
access repeater's call sign are
displayed.
After your call, 'RPT?' and the
destination repeater's call sign
are displayed.
Even when holding down
the DR screen is not displayed.
Even when you push
received call sign will not be set
to the destination call sign.
A Local area call can be
made, but a Gateway call, or
destination station call, cannot
be made.
"L" is displayed.
"DV" and "FM" icons alternately
blink.
Possible Cause
A repeater settings are incorrect.
Your transmission did not reach the
repeater.
The call was successfully sent, but
no station immediately replied.
Your own call sign (MY) has not been
set.
Your own call sign (MY) has not been
registered on a gateway repeater, or
the registered contents do not match
your transceiver's settings.
The call sign of the destination
repeater is incorrect.
The repeater cannot connect to the
destination repeater.
The repeater is busy.
There is no repeater list in your
,
transceiver.
The Lock function is activated.
The call sign has not been correctly
, the
received.
When a weak signal is received, or
a signal is received during scanning,
the call sign may not be received
correctly. In that case, "--------" is
displayed and error beeps sound,
and a reply call cannot be made.
MY call sign has not been registered. Register your own call sign (MY) on
The repeater set in "FROM" (Access
Repeater) has no Gateway.
While receiving through the Internet,
some packets may be lost due
to a network error (or poor data
throughput performance).
While in the DV mode, an FM signal
is received.
Select the correct repeater.
Correct the repeater frequency,
frequency offset, or duplex settings.
Wait until you are closer to the
repeater and try again.
Try to access another repeater.
Wait for a while, and try again.
Set your own call sign (MY).
Register your own call sign (MY) on
a gateway repeater, or confirm the
registration of the call sign.
Correctly set the destination
repeater's call sign.
Check the repeater settings.
Wait for a while, and try it again.
Import the list using a microSD card. p. 13-15
Directly enter the Repeater list data
into the transceiver.
Hold down
OFF the Lock function.
Try it again, after the transceiver
has correctly received the call sign.
a gateway repeater, or confirm the
registration of the call sign.
Check the repeater settings.
Wait a while, and try it again.
When the transceiver receives
corrupted data, and misidentifies it
is as packet loss, "L" is displayed,
even if it is a Local area call.
Use a different operating frequency
until there are no FM signals on the
original frequency.
13-17
Solution
p. 13-6
–
–
–
–
p. 13-3
p. 13-4
–
–
–
p. 14-23
–
for 1 second to turn
–
p. 13-4
p. 13-4
–
p. 14-16
REF�