D[Dial] Operation During A Scan; Dsquelch Setting For A Scan; Dtuning Step For A Vfo Scan; Dskip Function - Icom IC-V3500 Advanced Manual

SCAN OPERATION
4.
About scans

D[DIAL] operation during a scan

• Rotate [DIAL] to change the scan direction during a
scan�
• When the scan is paused, rotate [DIAL] to resume
the scan�

DSquelch setting for a scan

You can change the squelch level to suit your
operating needs� Set the squelch level to open the
squelch, according to the received signal strength�
During a scan, rotate [SQL] to adjust the squelch
level�

DTuning step for a VFO scan

The selected tuning step is applied to the scan�
For a Full scan and Programmed scan, set the tuning
step� See the Basic manual for details�

DSkip function

The Skip function speeds up scanning by not scanning
Memory channels set as Skip channels� (p� 4-11)

DWhen a signal is received

When a signal is received, the scan pauses for
approximately 10 seconds (default)�
The scan resumes approximately 2 seconds (default)
after the signal disappears�
To manually resume the scan, rotate [DIAL]�
These settings can be changed in the Set mode�
(p� 8-3)
Example: When receiving a signal during a Full
scan.
The S/RF indicator displays
the received signal strength�
MUTE
NAR
MID
LOW
LOCK ANM DUP
S ET MONI LOW
DIGITAL PRIO AO BUSY
"�" and "AL" blink�
T-SCAN PRIO SCAN
TONE M/CALL V/ MHz
4-3