When Operation Is Strange - GRAPHTEC LABERLROBO DLC1000 User Manual

When Operation is Strange

Symptom
The DATA lamp does not light or blink
even when data is transmitted.
Media is bowed.
The media has been set, but even
when the set lever is raise, "Please set
the media !" is displayed.
"E05 : RMS sensor error" is displayed. Mark is not printed in black on a white
"E50 : Command error" is displayed.
Cross cut (CROSS CUT) cannot be
done.
The cutting operation is not performed. Cutting data is not contained within the
A "Jamming" comes up.
Cause
Data is not being properly transmitted
The media is set at a slant.
There is a possibility that something
wrong has occurred in the operation of
the set lever sensor.
background, or is faded.
Media is set in a deviated state and
the mark is out of the search range.
(Rather than the above cause) when
this error frequently occurs, the
registration mark sensor failure is
considered.
The cross cut setting is OFF.
The separator (weeding) is not
separating.
data.
The dancer roller has not been set.
(Rather than the above cause) when
this error frequently occurs, the dancer
roller failure is considered.
6-3
Solution
Verify that the interface cable is
properly plugged in.
Correct the setting of the media.
Please contact the distributor where
you purchased this product or your
nearest Graphtec vender.
Check the print status of registration
marks.
Re-set the media.
Please contact the distributor where
you purchased this product or your
nearest Graphtec vender.
Check the data.
Please turn ON the cross cut setting in
the CUT CONDITION settings.
When the separator (weeding) does
not separate, the cross cut does not
perform.
Perform the separating (wedding)
operation.
Verify the data.
Set the dancer roller 1 and 2.
Please contact the distributor where
you purchased this product or your
nearest Graphtec vender.