(9) Coin Vendor installation(100V model only)
Coin vendor installation requires the following parts.
Coin Vendor (CV-1/ACV-1)
Bundled parts of Coin Vendor
Coin Vendor .............................................................1 pc
Vendor wire ..............................................................1 pc
Vendor base.............................................................1 pc
Screws (M4x6) .........................................................4 pcs
Spring washer screw M4x8 ......................................1pc
Procedures
1. Detach three screws.
2. Open the upper section of the rear top cover and detach in the direction of the arrow.
3. Detach four screws.
4. Open the lower section of the rear top cover and detach in the direction of the arrow.
Parts
Screw
Screw
Rear upper cover
Screw
Screw
Lower rear cover
Number
1
Screw
Figure 1-2-52
Screw
Screw
Figure 1-2-53
1-2-35
Parts number
- (Product)
2RG/2RH