Kyocera Copystar CS 3011i Service Manual page 381

(2) Table of general classification
Error code
U00000/E00000 No response or busy after the set number of redials.
U00100/E00100 Transmission was interrupted by a press of the stop/clear key.
U00200/E00200 Reception was interrupted by a press of the stop/clear key.
U00300/E00300 Recording paper on the destination unit has run out during transmission.
U004XX/E004XX A connection was made but interrupted during handshake with the receiver unit (See
page 1-4-91 ).
U00500/E00500 Multiple communication was interrupted and call was not made on destination units after
interruption.
U006XX/E006XX Communication was interrupted because of a machine problem (See page 1-4-92 ).
U00700/E00700 Communication was interrupted because of a problem in the destination unit.
U008XX/E008XX A page transmission error occurred in G3 mode (See page 1-4-92 ).
U009XX/E009XX A page reception error occurred in G3 mode (See page 1-4-92 ).
U010XX/E010XX Transmission in G3 mode was interrupted by a signal error (See page 1-4-93 ).
U011XX/E011XX Reception in G3 mode was interrupted by a signal error (See page 1-4-95 ).
U01400/E01400 An invalid one-touch key was specified during communication.
U01500/E01500 A communication error occurred when calling in V.8 mode.
U01600/E01600 A communication error occurred when called in V.8 mode.
U017XX/E017XX A communication error occurred before starting T.30 protocol during transmission in V.34
mode (See page 1-4-96 ).
U018XX/E018XX A communication error occurred before starting T.30 protocol during reception in V.34
mode (See page 1-4-97 ).
U02000/E02000 Relay broadcast was refused by a relay station because of a mismatch in permit ID num-
ber and permit telephone number when a relay command was issued.
U02100/E02100 A relay command failed because the destination unit (relay station) had no relay broad-
cast capability.
U02200/E02200 A relay command from a command station failed because a telephone number that was
not registered in the relay station was specified. Or, relay broadcast was requested to a
relay station but failed because a telephone number that was not registered in the relay
station was specified. Or, Subaddress-based relay broadcast transmission failed
because the data registered in the Subaddress relay box was deleted.
U023XX/E023XX Receiving station information was not normally received in reception of a relay command
(See page 1-4-97 ).
U02400/E02400 An interoffice subaddress-based relay transmission was interrupted because of a mis-
match in the specified relay box number.
U03000/E03000 No document was present in the destination unit when polling reception started.
U03100/E03100 In reverse polling, although no original was set in the destination unit, transmission was
complete.
U03200/E03200 In confidential polling reception, data was not accumulated in the specified box in the
destination unit. Or, in interoffice subaddress-based bulletin board reception, data was
not stored in the box specified by the destination unit.
Description
1-4-88
2RG/2RH