Kyocera Copystar CS 3011i Service Manual page 284

U935 Maintenance Relay Board
(Message: Maintenance Relay Board)
Contents
Set the disorder mode setting.
Purpose
Set when the disorder of the relay PWB occurs.
Execution
1.Press the [Start] key.
2.By using the [+] [-] keys or the numeric keys, change the setting value.
Mode 0
Mode 1
*: Initial setting: Mode 0
3.Press the [Start] key, determine the setting value.
Completion
Press the [Stop] key.
*: The screen for selecting a maintenance item No. is displayed.
U942 DP loop amount setting
(Message: Adjust DP Original Loop Amount)
Contents
Adjust the paper loop amount when using the document processor.
Purpose
Execute when original no-feed jam, skew or creases on the original appears.
Method
1.Press the [Start] key.
2.Press the [System Menu] key.
3.Place an original on the DP and press the [Start] key to make a test copy.
4.Press the [System Menu] key.
5.Select the item to adjust.
6.By using the [+] [-] keys or the numeric keys, change the setting value.
Items
Front
Back *1
Mix *2
*1: Reversing duplex scanning machine only, *2: except DP-7120
*: When the setting value is increased, the paper loop amount increase, and it decreases when the set-
ting value is decreased.
Items
Disorder setting mode invalidity
Disorder setting mode validity
Contents
Single-side original loop amount
Double-side original loop amount
Mixed original loop amount
Contents
Setting
range
-32 to 32
-31 to 31
-31 to 31
1-3-201
2RG/2RH
Initial Data
setting variation
0 0.20mm(DP-
7100)
0.16mm(DP-
7110)
0 0.18mm
0 0.18mm