Kyocera Copystar CS 3011i Service Manual page 43

1-2-4 Installing the optional equipment
(1) SD/SDHC memory card
Reading the SD/SDHC memory Card
The contents of the SD/SDHC memory card are read into the main unit after turning the power on.
SD/SDHC memory card installation
1. Turn off the main unit and disconnect the power cord and all interface cables.
* : Before inserting the memory card, make sure that the power switch is turned off.
2. Remove the screw (M3x8).
3. Release the hook in the direction of the arrow and then remove the SD card cover.
4. Install an SD/SDHC memory card in the memory card slot.
5. Reattach the covers.
Formatting an SD/SDHC Memory Card
To use an unused SD/SDHC card, you must first format it with the main unit.
* : Formatting will delete all existing data on the SD card.
If you have installed an application, do not format the SD card to avoid the removal of the application in
the SD card.
Format it with a PC or Prescribe command in advance.
Hook
SD cover
Figure 1-2-16
Memory card slot
SD/SDHC
memory card
Figure 1-2-17
1-2-16
Screw
2RG/2RH