Kyocera Copystar CS 3011i Service Manual page 38

The execution of toner installment
1.Turn the main power switch ON. The toner install is started.
* It takes about ten minutes till the state which is to be able to copy in the initial power ON.
2.If the toner installation completes, the drive stops.
The execution of Maintenance mode U952
1. Input "10871087" using the numeric keys and set the maintenance mode.
2. Input "952" using the numeric keys and press the [Start] key.
3. Select the [Execute] function.
4. Select [Full] and press the [Start] key.
* : When executing this simulation, the execution history is recorded.
* : Include the following clause in the maintenance mode U952 [SETUP].
If not executing the U952, set it in the following procedures.
[Cassette heater control setting(the execution of the maintenance mode U327)]
1. Input "10871087" using the numeric keys and set the maintenance mode.
2. Input "327" using the numeric keys and press the [Start] key.
3. Select "On".
4. Press the [Start] key and determine the setting.
5. Press the [Stop] key.
[Setting the machine delivery date (Execution of the maintenance mode U278)]
1. Input "278" using the numeric keys and press the [Start] key.
2. Select "Today".
3. Press the [Start] key and set the machine delivery date.
4. Press the [Stop] key.
[Output the status report (Execution of the maintenance mode U000)]
1. Input "000" using the numeric keys and press the [Start] key.
2. Select [Maintenance], press the [Start] key and output the status report.
3. Press the [Stop] key.
[Clearing the counts (Execution of the maintenance mode U927)]
1. Input "927" using the numeric keys and press the [Start] key.
2. Select the [Execute] function.
3. Press the [Start] key and clear the counts.
4. Press the [Stop] key.
1-2-11
2RG/2RH