Kyocera Copystar CS 3011i Service Manual page 216

Method: DP FU (Chart A)
Automatic input of the target value
1.Set the specified original (P/N: 7505000005) face-up on the DP.
2.Enter maintenance item U411.
3.Select [Target].
4.Select [Auto].
5.Press the [Start] key.
6.Select [DP FU(ChartA)].
7.Press the [Start] key to read the barcode of the original chart and to start the automatic adjustment.
8.When automatic adjustment has normally completed, [OK] is displayed.
*: When the error code "1e" or "1f" is displayed during the automatic adjustment in the DP scanning and the barcode
is not read, adjust the following after manually inputting the target value.
Manual input of the target value
1.Enter the target values which are shown on the lower part of the front page of the adjustment original (P/
N: 7505000005) by executing the maintenance mode U425.
2.Set the specified original (P/N: 7505000005) face-up on the DP.
3.Enter maintenance item U411.
4.Select [Target].
5.Select [U425].
6.Press the [Start] key.
7.Select [DP FU(ChartA)].
8.Press the [Start] key to start Auto adjustment.
9.When automatic adjustment has normally completed, [OK] is displayed.
Method: DP FD (Chart A)
Automatic input of the target value
1.Set the specified original (P/N: 7505000005) face-up on the DP.
2.Enter maintenance item U411.
3.Select [Target].
4.Select [Auto].
5.Press the [Start] key.
6.Select [DP FD(ChartA)].
7.Press the [Start] key to read the barcode of the original chart and to start the automatic adjustment.
8.When automatic adjustment has normally completed, [OK] is displayed.
*: When the error code "1e" or "1f" is displayed during the automatic adjustment in the DP scanning and the barcode
is not read, adjust the following after manually inputting the target value.
1-3-133
2RG/2RH