Kyocera Copystar CS 3011i Service Manual page 217

Manual input of the target value
1.Enter the target values which are shown on the lower part of the front page of the adjustment original (P/
N: 7505000005) by executing the maintenance mode U425.
2.Set the specified original (P/N: 7505000005) face-up on the DP.
3.Enter maintenance item U411.
4.Select [Target].
5.Select [U425].
6.Press the [Start] key.
7.Select [DP FD(ChartA)].
8.Press the [Start] key to start Auto adjustment.
9.When automatic adjustment has normally completed, [OK] is displayed.
*: When automatic adjustment has normally completed, [OK] is displayed. If an error occurs during auto
adjustment, error code "NGXX" is displayed and operation stops. In this case, check the error and exe-
cute the automatic adjustment again.
Error codes
Codes
00
01
04
05
06
07
08
09
0a
0b
0c
0d
Contents
Automatic adjustment success
Black band detection error
(Table scanning leading edge skew in the
sub-scanning direction)
Black band is not detected (Table leading
edge in the sub-scanning direction)
Black band is not detected (Table far end in
the main scanning direction)
Black band is not detected (Table near end
in the main scanning direction)
Black band is not detected (Table trailing
edge in the sub-scanning direction)
Black band is not detected (DP far end in
the main scanning direction)
Black band is not detected (DP near end in
the main scanning direction)
Black band is not detected (DP leading
edge in the sub-scanning direction)
Black band is not detected
(Original check of DP leading edge in the
sub-scanning direction)
Black band is not detected (DP trailing
edge in the sub-scanning direction)
White band is not detected (DP trailing
edge in the sub-scanning direction)
1-3-134
2RG/2RH
Corrective action
-
1. Set the original correctly and
execute the adjustment again.
2. Check lighting of the lamp or
replace it.
1. Check the attachment position of
DP.
2. Check lighting of the lamp or
replace it.
3. Check the back and front of the
adjustment original.