Activating The Sp-Ii Tpu - Klein 3000 Series Operation And Maintenance Manual

2. Turn on the laptop computer and wait for the Windows desktop to appear.
3. Turn on the SP-II TPU by switching the A/C-D/C switch to A/C for AC operation
or to D/C for DC operation.
4. Start Linux TPU Updater.
The Klein Linux TPU Updater dialog box opens.
5. Enter the SP-II TPU IP address in the Enter TPU IP Address text box if it is
different than the default address, or click
default address is 192.168.0.81. The address will already be displayed if it was
queried or changed as described in "Querying or Changing the SP-II TPU IP
Address" on page 5-12.
6. Click Update TPU Software .
An dialog box opens that enables file selection.
7. Select and open the update file to download and install.
The file is downloaded to the SP-II TPU and installed, and the SP-II TPU
software restarts. In about one minute a window opens confirming the
software update:
5.7

Activating the SP-II TPU

To activate the SP-II TPU:
Verify that the towfish has been properly set up and the system components
1.
connected.
2. Turn on the navigation system and let it acquire its location.
3. Verify that the tow cable is connected to the SP-II TPU and the towfish.
4. Turn on the computer and wait for the Windows desktop to appear.
NOTE Should it be required to change the IP address, edit the startup.ini
file or update the software of the SP-II TPU, refer to "Configuring and
Updating the SP-II TPU" on page 5-11.
Activating the SP-II TPU
if it is the default. The
Default Addr
5-15