Klein 3000 Series Operation And Maintenance Manual page 150

C-8
APPENDIX C General Setup, Configuration and Troubleshooting
An improper boot will hang the system and you may have to configure the TPU.
After a time out period, you will be put into the edit mode for the TPU. You will
now be able to edit the boot parameters. Enter c to change parameters.
Type the new parameter after the current parameter. If there are any other
parameters not noted below, leave them as they are. Entering "?" will give you a
help menu and entering "any key" before the boot sequence will put you in the edit
mode.
boot device
unit number
processor number: : 0...Leave as is
host name
file name
inet on ethernet (e) : 192.168.0.81...Address you give the TPU
host inet (h)
user (u)
ftp password (pw)
flags (f)
target name (tn)
startup script (s)
Turn the TPU off and then back on and watch the boot sequence again.
The Klein startup.ini file is used to set boot parameters. The following is a typical
.ini file.
set SONARTYPE 3000
set RANGE 2
set RESPDIV 15
set RESPFREQ 7
set DESPECKLESWITCH 0
set SPEEDFILTERSWITCH 1
set TVGPAGE 7
set SPEEDSOUND 150000
set BAUDRATE 4800
set STANDBYMODE 0
set DEFAULTUPLINK 0
set TOWFISHECHO 0
set DIAGLEVEL 1
Series 3000 Sonar System Operations and Maintenance Manual
: fei...Leave as is
: 0...Leave as is
: sonarclient...Name of your host PC as noted earlier
: \klein\vxWorks...Path to vxWorks on your computer
: 192.168.0.82
: klein..User name as set up earlier
: klein..User password as set up earlier
: 0x0...Sets boot delay to 10
: VxTarget...Set as is
: \klein\startup.ini...Location of startup.ini file
11210066, Rev. 11