Klein 3000 Series Operation And Maintenance Manual page 110

7-10
CHAPTER 7 S3000SBP Chirp Sub Bottom Profiler
Apply a thin film of
23.
silicone grease to the base
(rubber part) of the pins of
the hydrophone jumper
cable, and then connect the
cable to the hydrophone.
Do not over grease.
Secure the locking collar to
24.
the hydrophone.
Insert two of the supplied
25.
M5 socket head cap screws
through the slots on either
side of the aft sub bottom
towfish mounting bracket,
through the hydrophone
and through the slots on the
opposite side of the
bracket.
Using the 4-mm hex key
26.
and 3/4-inch adjustable
wrench, secure the bolts
with two of the supplied
M5 nylon locking nuts (not
shown).
Series 3000 Sonar System Operations and Maintenance Manual
Locking collar
Hydrophone Jumper Cable
Figure 7-16:
Connected to the Hydrophone
M5 socket head
cap screw (2)
Securing the Hydrophone—Aft
Figure 7-17:
End
11210066, Rev. 11