Klein 3000 Series Operation And Maintenance Manual page 106

7-6
CHAPTER 7 S3000SBP Chirp Sub Bottom Profiler
Remove the two tow
10.
brackets and the two hex
head bolts that secure them.
Store these components
away. They will not be
needed with the sub bottom
profiler installed.
Slide the supplied aft sub
11.
bottom towfish mounting
bracket over the stud
weldment at the aft end of
the towfish. The stud
weldment inserts into the
hole in the bracket, and the
tab in the bracket inserts
into the tab slot in the
towfish.
Series 3000 Sonar System Operations and Maintenance Manual
Removing the Tow Brackets
Figure 7-8:
Tab
Sliding the Aft Sub Bottom Towfish
Figure 7-9:
Mounting Bracket onto the Towfish
Hex head
bolt (2)
Aft sub bottom
towfish mounting
bracket
Aft end of
towfish
Tab slot
Stud
weldment
11210066, Rev. 11