ADC Release 3.1 User Manual page 486

1152700 Issue 1 February 2001 Section 2 Operations and Maintenance
Table 101-2. Alphabetical NMIC Generated Alarm Reports, continued
ALARM SEVERITY
MESSAGE
NMIC Full Minor
Database
Restoration
Failed
NMIC Full Informatio
Database nal Alert
Restoration
Needed
NMIC lost Informatio
connection nal Alert
with NMIC
application
NMIC lost Informatio
connection nal Alert
with NMIC
resources
agent
NMIC lost Informatio
connection nal Alert
with peer
NMIC
NMIC Informatio
Protection nal Alert
Change
Notification
NMIC Informatio
Protection nal Alert
Switch
Notification
Physical Major
Fiber Failure
Second Informatio
NMIC nal Alert
Plugged into
Invalid Slot
Page 2-442
© 2000, ADC Telecommunications, Inc.
IMPACT DESCRIPTION
Not Informs user that the NMIC
Service database restoration attempt
Affecting. has failed.
Not Informs user that the NMIC
Service cards (working and protect)
Affecting are out of sync.
Not Informs user that the NMIC
Service had a failure resulting in a
Affecting loss of connection with its
application.
Not Informs user that the NMIC
Service had a failure resulting in a
Affecting loss of connection with its
resource agent.
Not Working NMIC cannot
Service communicate with the
Affecting protection NMIC.
Not An informational alert
Service informing the user that the
Affecting protection mode has been
changed. This may be due to
a Lockout or an Automatic
Protection Switch (APS)
being initiated.
Not An informational alert
Service indicating the NMIC has
Affecting started the process of
switching to the protect card.
Not Network has experienced a
service failure on one of the fiber
affecting interconnections between the
nodes, indicated on the GUI
screen as an orange
connection.
Not Informs the user that the
Service protection NMIC is not
Affecting seated into the proper slot in
the backplane.
TAP-100
Page 23 of 23
SUGGESTED COURSE OF ACTION
Check statuses of NMICs and
reattempt database restoration.
Perform a database restoration
to synchronize the information
on the NMIC cards. Refer to
DLP-719.
This event will result in a
protection switch if the second
NMIC is in sync and protection
switching is enabled.
This event will result in a
protection switch if the second
NMIC is in sync and protection
switching is enabled.
Protection switching will not be
enabled at this point. Try
reseating standby NMIC. May
need to perform a database
restoration upon reestablishing
communication paths.
No action necessary. Verify the
protection operation change is
required and revert back if it is
not.
No action necessary. Verify
card switches properly upon
completion.
Check NE alarm reports at each
end of the fiber. Any LOS or
Section AIS on the hop may
cause this alarm.
Remove the protection NMIC
and reinstall into slots 4 and 5.