Delete A Cellworx Stn Node - ADC Release 3.1 User Manual

Release 3.1 gui
Table of Contents

Advertisement

NTP-010
Page 1 of 1
Summary: This procedure outlines the steps involved to remove a Cellworx STN ring node from
an in-service ring network, or an expansion shelf from an in-service condition. This procedure
enables the network administer to change the network configuration when required. It may be
necessary to remove a ring NE via software if the network is being uninstalled, or the equipment
at a site is being moved to a new location, etc. Before removing a node from the network, all
VP/VC connections to that node must be deleted.
DELETE A RING NODE FROM AN IN-SERVICE RING SYSTEM
1.
Launch the Cellworx Vision Graphical User Interface (GUI).
2.
Delete any VP/VC connections that are terminated at the node
being removed from service.
3.
Delete the node via the GUI using one of the following
procedures according to the type of node being removed:

Delete a Cellworx STN node.

Delete a Cellworx STN EPS shelf.
Stop! You have completed this procedure.
ADCP-70-220 Issue 1 November 2000 Section 2 Operation and Maintenance
DELETE A CELLWORX STN NODE
DLP-705
DLP-739
DLP-740
DLP-746
Page 2-25
© 2000, ADC Telecommunications, Inc.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Release 3.1 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Cellworx stn

Table of Contents

Save PDF