1152700 Issue 1 February 2001 Preface
ABOUT THIS MANUAL
This manual provides the system administrator with information necessary to turn up and test the
Cellworx Service Transport Node (STN), and/or services, as well as configure connections and monitor
the network using the CellworxVision Graphical User interface (GUI). Information provided within this
document deals primarily with the Phase 3.1 design features of the Cellworx STN system.
Trademark Information
The following trademarks are documented in this manual:
ADC and ADC Telecommunications are registered trademarks of ADC Telecommunications Inc.
Cellworx is a registered trademark of ADC Telecommunications Inc.
Open View is a registered trademark of Hewlett-Packard.
SRTS – Synchronous Residual Time Stamp is a patent of Bell Communications Research, Nov 9, 1993
Related Publications
Listed below are all of the related manuals and their publication numbers. Copies of these publications can
be ordered by contacting the ADC Technical Assistance Center at 1-800-366-3891 extension 63434 (in
U.S.A. or Canada) or 612-946-3434 (outside U.S.A. and Canada).
Title/Description
Application and Engineering Guide 3.1
Contains an introduction to the ADC Cellworx STN system, hardware and software
descriptions, applications, and engineering information required for system deployment.
Craft User's Manual 3.1
Contains information required for provisioning, operation, and administration of the
Cellworx STN system through the craft access. Information includes detecting and isolating
alarms, and turn up of features over the entire network.
System Description Manual 3.1
Combines information from the Users Manual, Installation Manual, and Applications
Engineering Manual to provide introductory information and a general overview of the
Cellworx STN system.
Cellworx CLEI Code Guide
Lists all CLEI codes used to order Cellworx equipment.
Page viii
© 2000, ADC Telecommunications, Inc.
Part Number
1152699
1152703
1152712
1112344
Need help?
Do you have a question about the Release 3.1 and is the answer not in the manual?
Questions and answers