Nmic Rs232 Interface; Nmic Eim Rj45 Ethernet Interface; A.nmic Rs232 Interface; B.nmic Eim Rj45 Ethernet Interface - ADC Release 3.1 User Manual

A.

NMIC RS232 Interface

The NMIC provides an asynchronous RS-232 port for character based access
provided through a DB9 connector located under the front hinged faceplate. This
port is used to load the operating system information and IP addresses at initial
network turn up.
RS232 PORT
Figure 1-2. NMIC Craft Port Identification
B.

NMIC EIM RJ45 Ethernet Interface

An external Network Management System (NMS) and/or X-Terminal connection is
provided through an RJ45 10 Base-T Ethernet connection on either NMIC
Electrical Interface Module (NMIC EIM) in slot 2 or 4 at the rear of the shelf.
Refer to Figure 1-3. This connection is available only in the Gateway Network
Element (GNE) located at a Central Office or controlled environment (0-50 C)
location. It provides access to the GUI software screens for all management
ADCP-70-220 Issue 1 September 2000 Section 1 Introduction
JA7
P5
E11
1173
J1
Figure 1-3. NMIC EIM Port Identifications
© 2000, ADC Telecommunications, Inc.
P1
A
GND
B
GND
U2
J6
RJ45 ETHERNET
CONNECTION
J2
9 PIN D-SUB EXTERNAL
EQUIPMENT PORT
10490-A
Page 1-3