Leuze electronic BPS 34 Technical Description page 83

Leuze electronic
Input data
Input data
c
Signals the current state of the
internal velocity measurement
State
of the BPS 34
Input data length: 1 byte
Notice!
These input data signal the state of the BPS 34:
• Init: Base setting during initial startup of the BPS 34
• Idle: The BPS 34 is in idle state (scanning beam is off, but motor is running)
• Measure: The BPS 34 is in measurement state (data are output in module 1)
• Standby: The BPS 34 is in waiting state (laser off and motor off).
Output data
Output
data
d
Event starts velocity measure-
Start
ment.
event
Event stops velocity measure-
e
Stop event ment.
f
Defines whether the current
Min/Max
velocity is included in min/max
velocity
recording.
mode
g
Min/Max Reset the min/max velocity val-
velocity ues.
reset
Output data length: 1 byte
Leuze electronic
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Description Rel.
addr.
0
Description Rel.
addr.
0.0
0.1
0.2
0.3
Device parameters and interfaces
Data Value range
type
0: Init
unsign 1: Idle
8 2: Measure
4: Standby
Data Value range
type
Bit 0 -> 1: Start
Bit 0 -> 1: Stop
0: Do not record min/max
Bit
1: Record min/max
Bit 0 -> 1: Reset
BPS 34
Default Unit CR to
module
0 – –
Default Unit CR to
module
0 – –
0 – –
0 – 24
0 – 24
81