Repair Kit - Leuze electronic BPS 34 Technical Description

Leuze electronic
Notice!
When affixing the BCT in a system in which the end of one BCT meets the start of another
BCT (position value X with position value 0), ensure that position labels 0 - 20 are not used.
This means that position label 24 must be the first label used on the continuing barcode tape.
Notice!
If only the "MVS" label is read within the scanning beam, the scanning beam must not be
interrupted during the read operation until the scanner can again read a complete position
label.
If only the "MVS" label is located in the scanning beam, the voltage on the BPS 34 must not
be switched off. Otherwise the BPS 34 will return a position value of zero when the voltage
is switched back on.
Moreover, the scanner must not be configured while in this position. Otherwise, a value of
zero is output as long as no position label is present in the scanning beam due to the fact
that the scanning beam is switched off during configuration.
6.5

Repair kit

Notice!
If the barcode tape was damaged, e.g. by falling parts, a repair kit can be downloaded from
the Internet ( Leuze website -> Under the heading Download ->
Logistics -> Optical barcode positioning -> Repair Kit for Barcode Tape).
In these 4 files you will find all code information for a tape with lengths of 0 ... 500 m,
500 ... 1000 m, 1000 ... 1500 m and 1500 ... 2000 m. 1 m of barcode tape is provided on
each A4 sheet. Each metre is divided into 5 lines of 20 cm, each with 5 code segments of
information covering lengths of 4 cm each.
Procedure when replacing the defective area:
1. Determine the coding of the defective area.
2. Print out the area determined to be defective
3. Affix the printed area over the defective location
Leuze electronic
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
BPS 34
Barcode tape
35