Leuze electronic BPS 34 Technical Description page 74

Device parameters and interfaces
8.1.7.16 Module 15: Static position limit value 2
Description
The limit value function compares the output position value with a position stored during
parameterisation. If the value is above or below the limit value, the limit value status 2
(module 12) is set and, if configured, the switching output (module 8) is appropriately set.
Parameter
Parameter Description
a
Parameter activates limit
Limit value
value checking.
mode 2
Condition for the signal
b
change of the switching out-
Switching
put/status bit.
mode 2
c
Relative offset of switching
Hysteresis 2
point
in [mm]
d
Limit value is compared to the
Limit value 2
current position value.
in [mm]
Parameter length: 8 byte
Hex coding of module 15 "Static position limit value 2"
The value listed in the table shows the hex coding of the default settings.
0E
Input data
none
Output data
none
Notice!
With this module, the settings for the Preset (module 3), Offset (module 5) and Scaling
(module 6) modules must be taken into account.
72
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Rel.
addr.
0
1
2
4
00 00 00 00
Data Value range
type
unsign 0: Off
8 1: On
unsign 0: Value greater than limit
8 1: Value less than limit
unsign
0 ... 65'535
16
sign32 -10'000'000 ... 10'000'000
00 00 00 00
BPS 34
Leuze electronic
Default Unit CR to
module
0 – 7 g
0 –
0 mm
0 mm 12f
Leuze electronic
8d
–