Leuze electronic BPS 34 Technical Description page 64

Device parameters and interfaces
e
The parameter specifies the events
which reset the switching output:
- velocity valid
- velocity not valid
- position limit value 1 reached
- position limit value 1 not reached
- outside measurement range
- inside measurement range
Switch-off
- position limit value 2 reached
function
[OFF] - position limit value 2 not reached
- erroneous measurement
- successful measurement
- PROFIBUS positive edge
- PROFIBUS negative edge
- velocity limit value reached
- velocity limit value not reached
Parameter length: 8 byte
Notice!
The events of the switch-on function and switch-off function are both linked to one another
with a logical OR.
Hex coding of module 8 "Switching output"
The value listed in the table shows the hex coding of the default settings.
02
Input data
none
Output data
Output data
This bit can be used to operate
f
the switching output if the
Switching output
"PROFIBUS edge" function is
PROFIBUS edge
configured.
Output data length: 1 byte
Notice!
With the "PROFIBUS edge" function, the switching output can be directly activated or deac-
tivated by setting bit 0.0.
62
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
00 00 01 90
Description
6.0
6.1
6.2
6.3
6.4 for each
6.5 Bits 0: Not active
6.6 1: Active
6.7
7.2
7.3
7.4
7.5
7.6
7.7
04 00 08 00
Rel. Data Value range
addr. type
0 -> 1: Positive edge
0.0 Bit
1 -> 0: Negative edge
BPS 34
Leuze electronic
0
0
0 14 + 16
0 14 + 16
0
0 –
0 15 + 17
0 15 + 17
0 1 + 9
1 1 + 9
0
0
0
0
Default Unit CR to
module
0 –
Leuze electronic
22
22
10
10
8
8
25
25
–