Leuze electronic BPS 34 Technical Description page 76

Device parameters and interfaces
8.1.7.18 Module 17: Dynamic position limit value 2
Description
The limit value function compares the position value with a stored position. If the value is
above or below the limit value, the limit value status 2 in module 12 is set and, if configured,
the switching output is appropriately set.
The limit value is transferred to the BPS 34 together with the output data of this module by
the PROFIBUS master.
Parameter
Parameter Description
a
Parameter activates limit
Limit value
value checking.
mode 2
Condition for the signal
b
change of the switching out-
Switching
put/status bit.
mode 2
c
Relative offset of switching
Hysteresis 2
point.
in [mm]
Parameter length: 4 byte
Hex coding of module 17 "Dynamic position limit value 2"
The value listed in the table shows the hex coding of the default settings.
10
Input data
none
Output data
Output data Description
d
Limit value is compared to the
Limit value 2
current position value.
in [mm]
Output data length: 4 byte
Notice!
With this module, the settings for the Preset (module 3), Offset (module 5) and Scaling
(module 6) modules must be taken into account.
74
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Rel.
addr.
0
1
2
00 00 00 00
Rel.
addr.
0
Data Value range
type
unsign 0: Off
8 1: On
unsign 0: Value greater than limit
8 1: Value less than limit
unsign
0 ... 65'535
16
Data Value range
type
sign32 -10'000'000 ... 10'000'000
BPS 34
Leuze electronic
Default Unit CR to
module
0 – 7 g
0 –
12f
0 mm
Default Unit CR to
module
0 mm
Leuze electronic
8d
–
–