Leuze electronic BPS 34 Technical Description page 71

Leuze electronic
8.1.7.14 Module 13: Min/Max position
Notice!
Underlined in the CR column are the modules which must be activated in addition to the cur-
rent module.
Description
The Min/Max position function monitors the position value and transfers the maximum/
minimum value to the PROFIBUS master.
The acquisition time can be adjusted by means of two different modes:
• The "all values" mode detects all values since the start of measurement or since a
reset event.
• The "in measurement value window only" mode only detects extreme values which
occur in the time period defined in the "MinMax period" parameter.
Parameter
Parameter
a
Parameter activates Min/Max
MinMax
evaluation function.
mode
b
Defines the measurement value
MinMax
window for the min-max values.
period
Parameter length: 2 byte
Hex coding of module 13 "Min/Max position"
The value listed in the table shows the hex coding of the default settings.
0C
Leuze electronic
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Description Rel.
addr.
0
1
00 0A
Device parameters and interfaces
Data Value range
type
0: Off
unsign 1: All values
8 2: In measurement value
window only
unsign
0 ... 255
8
BPS 34
Default Unit CR to
module
0 –
Measure-
10
ments
–
–
69