Leuze electronic BPS 34 Technical Description page 51

Leuze electronic
Module
Page
M22
page 80
M23
page 82
M24
page 84
M25
page 85
M26
page 88
M27
page 90
Table 8.1:
Leuze electronic
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Module name
Control
velocity
measurement
Status
velocity
measurement
Min/Max
velocity
Static velocity limit
values
(for limit value 1 ... 4)
Dynamic
velocity
limit values
Tape value correction
Overview of the GSE modules
Device parameters and interfaces
Module contents
(P) = Parameter, (O) = Output, (I) = Input
(P) Start mode of velocity measurement
(P) Velocity measurement stop mode
(I) Velocity measurement status
(O) Start event
(O) Stop event
(O) Min/Max velocity mode
(O) Min/Max velocity reset
(I) Measurement error
(I) Limit value status 1 exceeded
(I) Limit value status 2 exceeded
(I) Limit value status 3 exceeded
(I) Limit value status 4 exceeded
(I) Dynamic limit value status exceeded
(I) Movement status
(I) Direction of movement
(I) Compare limit value status 1
(I) Compare limit value status 2
(I) Compare limit value status 3
(I) Compare limit value status 4
(I) Compare dynamic limit value status
(I) Minimum velocity
(I) Maximum velocity
(P) Velocity limit value mode (active/not active)
(P) Direction selection (both directions or only one)
(P) Switching mode (value is above or below the
defined limits)
(P) Velocity limit value
(P) Hysteresis
(P) Range start
(P) Range end
(O) Limit value control
(O) Switching mode (value is above or below the
defined limits)
(O) Direction selection
(O) Limit value
(O) Hysteresis
(O) Range start
(O) Range end
(P) Actual length
(P) Range start
(P) Range end
BPS 34 49