Commissioning Steps At A Glance - Leuze electronic BPS 34 Technical Description

Commissioning steps at a glance

3 Commissioning steps at a glance
Notice!
Below you will find a short description for the initial commissioning of the barcode po-
sitioning system BPS 34. Detailed explanations for all listed points can be found throughout
the handbook.
➀
Mechanical design
Mounting the barcode tape
The barcode tape is to be affixed without tension to a dust- and grease-free mounting
surface.
➔
chapter 6.3 on page 29
Mounting the BPS 34 device
There are two different types of mounting arrangements for the BPS 34:
1. Using 4 M4x6 screws on the rear of the device.
2. Using a mounting device (BT 56) on the dovetail fastening grooves.
Notice!
The installation dimensions listed in the following figure must absolutely be adhered to. Op-
tically, it must be ensured that the scanner has an unobstructed view of the barcode tape at
➔
all times.
Barcode tape
000200 0
all dimensions
in mm
Figure 3.1:
➔
chapter 7.1 on page 37
8
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
chapter 7.2 on page 40
Centre of the scanning beam
(device centre, output position value)
000204 000208 000212 2
Beam exit and device arrangement of the BPS 34
10˚
2 000216
10˚
10 ° pitch
in the vertical
axis
(dependent on
the tape height,
see notice)
BPS 34
Leuze electronic
Scanning beam
Read distance
Leuze electronic