KRTM 3B Specifications Remarks Optical data UL REQUIREMENTS Scanning range 14.5mm ± 2mm Enclosure Type Rating: Type 1 Light spot dimensions in RUN-Mode 1.5mm x 4mm (at a distance of 14.5mm) For Use in NFPA 79 Applications in Teach-Mode 1.5mm x 6.5mm (at a distance of 14.5mm) only.
KRTM 3B IO-Link process data The sensor transmits 2 bytes to the master. Data bit Assignment Default settings 15 14 13 12 11 10 Switching output 0 = no mark, 1 = mark detected Not assigned Free Sensor operation 0 = off, 1 = on Switching threshold LSB Value range 0 …...
Page 5
Yellow LED is off. 7 … 12s Alternating Value is accepted. High sensitivity is set. flashing Leuze electronic GmbH + Co. KG In der Braike 1 D-73277 Owen Tel. +49 (0) 7021 573-0 KRTM 3B… - 08 info@leuze.com • www.leuze.com...
Page 6
KRTM 3B Switching threshold diagrams Static 2-point teach Label with marks 1. Teach point on background 2. Teach point on mark Receive signal Switching threshold in center Switching threshold near the mark Switching output for switching threshold in center Switching output for switching threshold near the mark Dynamic 2-point teach Label with marks...
Page 7
If the upper or lower end of the adjustment range is reached, the green and yellow LEDs flash at a considerably higher frequency of 8Hz for the duration of one second. Leuze electronic GmbH + Co. KG In der Braike 1 D-73277 Owen Tel. +49 (0) 7021 573-0 KRTM 3B…...
Page 8
KRTM 3B Sensor adjustments via the input IN (Pin 2, not for KRTM 3B/L6…) The following description applies to PNP switching logic! Signal level LOW ≤ 2V Signal level HIGH ≥ (U -2V) With the NPN models, the signal levels are inverted! Switching threshold in center / standard sensitivity Accept 1st teach value Accept 2nd teach value...
This manual is also suitable for:
Krtm 3b/6.1121-s8Krtm 3b/4.1121-s8Krtm 3b/4.1221-s8Krtm 3b/2.1121-s8Krtm 3b/4.1121,200-s12Krtm 3b/2.1121,200-s12...
Show all